Jul
How to Propagate Juniper Through Air Layering
Almost 70 species of junipers exist around the globe, from the chilly northern taiga to the deserts of the eastern Mediterranean. Many species of juniper are cultivated as landscape ornamentals for their beautiful needle-like foliage and tolerance for arid rising circumstances, and quite a few gardeners seek to propagate new juniper specimens at residence making use of an present mother or father plant. Air layering supplies one solution for propagating new juniper trees from a balanced, mature mother or father plant, but it ought to be performed in early spring ahead of the tree completely emerges from dormancy.
Problems:
Reasonably Easy
Directions
Items You’ll Need to have
Sphagnum moss
Utility knife
.five-percent IBA (indole butyric acid) rooting hormone
String
one-gallon plastic sandwich bag
Electrical tape
Anvil shears
1-gallon nursery container
Sharp sand
Backyard soil
one
Position two cups of sphagnum moss in a bowl stuffed with h2o. Soak the moss for quite a few hrs before proceeding with the air layering approach.
two
Find a suited branch for air layering on a nutritious, mature juniper tree. Locate a side branch measuring at least 18 inches in duration with a diameter no larger than one/four inch.
3
Measure twelve inches from the tip of the branch. Remove the foliage from a 4-inch portion of the branch twelve inches from the tip.
4
Eliminate the sphagnum moss from the bowl of water. Allow it to drain while preparing the branch.
5
Score all around the bark at the leafless portion of the juniper branch making use of a utility knife. Press into the branch just deep ample to reduce by means of the bark. Measure 1 inch below the to begin with reduce and score about the bark once more.
6
Make a vertical slice between the two scoring marks on each side of the branch. Peel away the two halves of the bark so the inner layer of the branch is uncovered.
7
Brush a light layer of .5-percent IBA rooting hormone onto the uncovered portion of the branch. Use a paintbrush or cotton swab to utilize the hormone.
eight
Squeeze the extra drinking water from the sphagnum moss. Wrap it all around the hormone-taken care of portion of the juniper branch. Secure the moss with string.
9
Slice alongside two sides of a one-gallon plastic bag to build a single large sheet of plastic. Wrap the plastic all over the bundle of moistened sphagnum moss. Secure the plastic around the sphagnum moss applying electrical tape.
ten
Observe for rooting in three to 4 weeks. Search for little white roots poking as a result of the sphagnum moss.
eleven
Sever the juniper branch just beneath the bundle of sphagnum moss using a pair of sharp anvil shears as soon as it roots efficiently.
12
Fill the bottom 50 % of a one-gallon nursery container with a mixture of equal areas sharp sand and garden soil.
13
Unwrap the sphagnum moss from close to the roots of the juniper branch. Hold the juniper branch upright in the container. Backfill close to the base with extra of the sand and soil combination till the major of the soil is flush with the foliage.
14
Arranged the potted juniper branch outdoors in a warm, partially sunny spot with protection from the wind. Maintain it in its container right until it places on obvious progress and seems to be thriving, then plant it in a everlasting bed.
<div
